D
E
T
A
I
L
S
Solar Charge Controller (Normal Rating)
Solar Charge Controller (Normal Rating)

Solar Charge Controllers

Solar Charge Controller (Normal Rating)

Solar charge controller is an advanced Maximum Power Point Tracking battery charger for Photo-Voltaic (PV) systems. The controller features a smart tracking algorithm that maximizes the energy harvest from the PV and also provides load control to prevent over-discharge of the battery.

There are a number of protections that the Solar Charge Controller ensures. Solar Charge Controller stops reverse current flow from battery to solar array, it provides load short circuit protection, it provides Battery/Panel reverse protection through DC fuse and Overload protection also.Solar charge controller is an advanced Maximum Power Point Tracking battery charger for Photo-Voltaic (PV) systems.

Install Charge Controller:


Step-1: Connect positive (+ve) Battery terminal to the positive (+ve) terminal of Charge Controller terminal blockwhich is marked as ‘Battery’. Now, Connect negative (-ve) Battery terminal to the negative (-ve) terminal of Charge Controller terminal block.

Step-2: Connect positive (+ve) PV terminal to the positive (+ve) terminal of Charge Controller terminal blockwhich is marked as ‘SPV’. Now, Connect negative (-ve) PV terminal to the negative (-ve) terminal of Charge Controller terminal block.
Note: Please first check the PVoc of the PV panel according to the system rating.

Step-3: Switch on SPV MCB first. SPV ON buzzer will buzz along with SPV ON LED (green) will solid glow then wait for 30 second. LCD will glow and start showing respective SPV volt. And batt. volt. After 30 sec. charger will ON with a buzzer and chg. ON & Batt CHD. LED will solid glow.

Step-4:
 Now switch ON battery MCB, after assuring correct polarity. BATT. FULL LED (green) will OFF, CHG. ON LED will blink and charging current will start to flow.