D
E
T
A
I
L
S
Solar Charge Controller (High Rating)
Solar Charge Controller (High Rating)

Solar Charge Controllers

Solar Charge Controller (High Rating)

 The Solar charge controller based on rMPPT technology . The controller features a smart tracking algorithm that maximizes the energy harvest from the PV and also provides load control to prevent over-discharge of the battery.  Extra power gathered from the modules is then made accessible as increased battery charge current. With rMPPT innovation the charge efficiency  can be expanded by up to 30%, reducing the size of the array required and saving on installation costs .
 

Install Charge Controller:


Step-1: Connect positive (+ve) Battery terminal to the positive (+ve) terminal of Charge Controller terminal block which is marked as ‘Battery’. Now, Connect negative (-ve) Battery terminal to the negative (-ve) terminal of Charge Controller terminal block.

Step-2: Connect positive (+ve) PV terminal to the positive (+ve) terminal of Charge Controller terminal block which is marked as ‘SPV’. Now, Connect negative (-ve) PV terminal to the negative (-ve) terminal of Charge Controller terminal block.
Note: Please first check the PVoc of the PV panel according to the system rating.

Step-3: Switch on SPV MCB first. SPV ON buzzer will buzz along with SPV ON LED (green) will solid glow then wait for 30 second. LCD will glow and start showing respective SPV volt. And batt. volt. After 30 sec. charger will ON with a buzzer and chg. ON & Batt CHD. LED will solid glow.

Step-4:
Now switch ON battery MCB, after assuring correct polarity. BATT. FULL LED (green) will OFF, CHG. ON LED will blink and charging current will start to flow.